Installation of Quick Release Detachable Sissy Bar (Back Rest)

Postponed the job yesterday since one of my brothers need fly to Oman. I need to sent him to Hamad International Airport.

 Today I've ample time to complete my job for this installation. Lets have a review how to complete this.

 Hand tools required.

1. Torx wrench ( not torque wrench) T40.

2. Combination spanner 1/2".

3. Allen key set - Imperial.

4. Loctite.

T40

 Remove the tork bolt. Only frontside required spanner to loose it, for the rear side its only attached with small plate which have been threaded. This plate attached to the main frame of rear fender.

 Next, Identify for each rubber mount spacer. Short for the front side and long for the rear. Install the long bolt which have provided by seller ( in my case it allen key type not torx) .Apply loctite and tight with bolt for the front side.

Front side rubber mounting.

 Do the same for rear side but make sure the plate slot in properly in the main frame of the rear fender.

Rear rubber mounting. Bit longer than front.

 

 Lastly, install the back rest sissy bar. Looks great for me, so how about you?

Tadaaaaaaaa.....